This power controller can operate as many as six SW-60 syringe warmers.
- Compact design
- Both local and global control of syringe temperature
- Independent temperature control for each channel
- Separate monitoring of set point and heater temperature
- Digital readout
- Optimized for use with up to six 60 cc syringes
Solution reservoir heating is an important technique used to eliminate outgassing in heated solutions. Since the gas load of a solution is dependent on pressure and temperature, preheating a solution at atmospheric pressure prior to delivery to a warmed environment will minimize the occurrence of bubbles in the bath, even if the solution is allowed to cool en route.
The Syringe Warmer System from Warner Instruments is comprised of the SW-707 Syringe Heater Controller, a PS-560 Syringe Heater Stand and up to six SW-60 Syringe Heaters. Each SW-60 accommodates a single 60 cc syringe. This system has been optimized to provide accurate regulation of solution temperature during preheating.
The temperature of a syringe heater can be set by either local or global control. Local control is selected by setting the associated channel MASTER/LOCAL toggle switch to local on the SW-707. In either local or global mode, the LED on the syringe warmer will cycle in parallel with the associated LED on the power controller.
When used in the local mode, the SW-707 allows the temperature of each syringe block to be independently set. A master mode allows all syringe blocks to be set to the same temperature. Both the set temperature and the actual temperature of each syringe block can be displayed on the LED meter.
Temperature Range Ambient to 50 °C
Max. Output 12 V CD, 144 W
LED Display Monitors set and read temperatures
Power Requirements 100-130 or 220-250 V AC, 50/60 Hz, 140 VA
Physical Size H x W x D 9 x 22 x 26 cm
Weight 3.63 kg
Warranty 2 Year